Skutt EnviroVent 2 Manuel d'utilisateur télécharger pdf (Page 7)

seTup

StEp 5 - inStalling thE plEnum cup and Spring Stand

• Using gloves to protect your hands, stretch the ex tubing to the proper length for

your installation. Stretch out the last 3” of tubing on each end of the duct to ensure

they are wide enought to t over their connections. Be careful not to collapse the

open end of the ex tubing. You should be able to stretch the ex tubing 6 ft. to 8 ft.

• Attach the length of 3” diameter aluminum ex tubing to the 3” sleeve on the ple-

num cup and secure with the hose clamp.

• Place the spring over the plenum cup stand post and insert the 7/16” stand post

into the small hole in the bottom of the aluminum plenum cup. Refer to the instal-

lation drawing if necessary. When properly assembled the plenum stand should be

spring loaded into the bottom of the plenum cup.

• Place the plenum cup and stand under the holes drilled in the kiln oor by rotat-

ing the cup horizontally, compressing the spring to permit cup rotation to vertical

and releasing the spring tension. Ensure that the plenum cup is centered under the

holes in the kiln’s oor.

StEp 6 - inStalling thE blowEr and motor aSSEmbly

• Locate a spot on the wall to mount the blower assembly and discharge tube. Im-

portant: Choose a spot that is close enough for the aluminum ex tubing to reach.

Remember that most kilns must be a minimum of 18” from the wall. If possible,

locate a spot that allows you to mount the vertical edge of the mounting plate into

a wall stud or ceiling joist. If you need to go further then the ducting will allow

consult the Custom Installation section of this manual.

• Drill a 3 1/8” clearance hole in the wall or ceiling to accept the 3” diameter dis-

charge pipe. Be sure to check for wires and pipes in the wall prior to drilling.

• Insert the discharge pipe through the 3 1/8” hole and fasten the mounting plate in

place using the supplied sheet metal screws or toggle bolts. Choose the proper fas-

tener for your wall type of material. If you are using the toggle bolts you will need

to position the mounting plate and mark where the holes will be. Predrill the holes

for the toggle bolts using a 3/8” drill bit . The 3” metal discharge tube is supplied

at 8” in length. This tube may be trimmed shorter or added to in order to allow for

any installation.

• Attach the open end of the aluminum ex tube to the blower inlet ange using the

hose clamp provided. Check the plenum cup assembly to make sure it has not

shifted out of place.

• We recommend attaching a hood with a screen over the end of the discharge tube.

This will help prevent snow, rain or debris from entering into the discharge tube

or blocking the air ow. The screen is also important to prevent small animals and

insects from entering the tube. This item is not included with the kit but can usually

be found at local hardware stores.

floor mountEd vEntS

A bolt-on plate comes with your kit and allows you to place the vent motor on the oor when wall-mounting

is not possible. To install, just bolt the oor plate onto the bottom lip of the mounting plate using the hardware

included in the kit. This allows the motor to sit upright on the oor. Install ducting to the discharge tube and

vent it as you would a dryer making sure all joints are airtight. When the vent is oor mounted it is no longer a

negative pressure system.

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Commentaires sur ces manuels

Pas de commentaire

Skutt EnviroVent 2 Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Skutt EnviroVent 2