Skutt EnviroVent 2 Manuel d'utilisateur télécharger pdf (Page 8)

seTup

StEp 7 - tESting thE EnvirovEnt2 for propEr

opEration

• Check to make sure the plenum cup has not shifted

during installation. It should be perpendicular to

the oor and have a good seal to the bottom of the

kiln.

• Plug the EnviroVent2 power cord into a 110 - 120

volt outlet.

• Turn on the blower by activating the switch in the

power cord. Ensure that the blower motor starts

and operates normally. If the blower doesn’t start

or the sound of air passage is not evident, immedi-

ately unplug the blower and check for the cause of the malfunction.

• Close the lid of the kiln.

• Install all peep plugs.

• Ensure that no other kiln openings are left open except the drilled holes in the kiln lid.

• Test your new vent system by placing a lighted match directly over and level with one of the lid holes. The

ame from the match should be pulled into the kiln as a result of the draft. If you are unsure of the eect of

the draft, observe the action of the ame away from the hole and then move it over the hole. If the ame is

not pulled into the kiln, the kiln is not venting properly. See page 13 on Troubleshooting. Repeat this test

regularly to ensure continuing accurate operation.

tESting prEviouSly drillEd lidS

As mentioned earlier it may not be necessary to patch existing holes. If there are more holes, or holes with a

larger diameter than this manual recommends in your kiln lid, you may not be able to ame test it as previously

recommended. If a ame is not drawn through the lid try covering up some of the holes in the lid. If after cover-

ing all the holes in the lid you still cannot get a ame to draw down into the chamber, contact your distributor for

further instruction.

chEcking thE plEnum cup

The oor of a 12 sided kiln will ex up to 1/4” due to the uneven heating of the oor. The spring loaded action

of the EnviroVent2 will allow the plenum cup to rise and fall with the exing of the kiln oor. If the 3” aluminum

ex is kicked, bumped or otherwise dislodged, the position of the plenum cup may change. If this occurs, simply

look at the plenum cup to ensure it is positioned properly. To reposition the plenum cup simply push down on

the cup to release the spring pressure, reposition the cup and let go.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Skutt EnviroVent 2 Manuel d'utilisateur Page 8