Skutt EV2 Rolling Stand Adapter Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Équipement Skutt EV2 Rolling Stand Adapter. Skutt EV2 Rolling Stand Adapter User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 1
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
6441 SE Johnson Creek Blvd., Portland, OR 97206 Phone (503) 774-6000 Fax (503) 774-7833
www.skutt.com
TAB TEXT HERE TAB TEXT HERE TAB TEXT HERE TAB TEXT HERE
SERVICE TRAINING MANUAL
14.19 REV 12/26/14
UPGRADES
The EnviroVent2 Rolling Stand Adapter Kit allows you to install your EnviroVent 2 and still be able to
roll your kiln short distances without having to readjust the spring loaded collection cup. This is made
possible by inserting a bracket into the frame of the stand. The spring loaded collection cup achieves the
compression it needs to keep a tight seal with the bottom of the bracket instead of the oor so it is able to
travel with the kiln.
1. Unplug your kiln from the wall. If your kiln is direct wired, turn the breaker or disconnect
switch to the o position.
2. Follow the instructions in your manual for disassembling your kiln to remove it from the stand.
If this is a new kiln, you will not be using the standard stand that comes with the kiln.
3. Assemble the Rolling Stand Adapter as pictured in Photo A using your existing collection cup.
Make sure the bottom nut is ush with the end of the bolt so you get the maximum compression
possible. Once the bottom nut is in position, tighten the nut on the other side of the bracket.
4. Place assembled Adapter into your rolling stand in the exact center as pictured in Photo B. Some
of the stands have dierent spacing between the crossbars. It is okay if the anges overlap as
they do in Photo B. The weight of the kiln will keep it in place.
5. Place the bottom slab of the kiln onto the stand making sure the holes drilled in the slab line up
within the inner diameter of the collection cup (Photo C).
6. Follow the instructions in the manual for reassembling the kiln, roll it to the desired position in
the room and lock in the casters (Photo D).
7. Attach your ducting to the collection cup and perform a ame test to make sure the cup is
aligned properly (see EnviroVent2 Manual).
EV2 Rolling Stand Adapter
B
DC
A
Vue de la page 0
1

Résumé du contenu

Page 1 - EV2 Rolling Stand Adapter

6441 SE Johnson Creek Blvd., Portland, OR 97206 Phone (503) 774-6000 Fax (503) 774-7833www.skutt.comTAB TEXT HERE TAB TEXT HERE TAB T

Commentaires sur ces manuels

Pas de commentaire